Knowledgebase
Polycom SoundPoint IP 501, 550, 650, etc.
Posted by HostPBX US on 29 August 2013 02:40 PM

Configuration Details

Get the IP

Start the Phone and it will get an IP from the DHCP Server, then it will display the IP on the Screen.


Configure Settings

  • Enter the IP address on your web browser (PC and Device should be on the same network)
  • The browser should load the configuration page for the IP 501
  • Click on Sip Link
  • Enter User and Password (default values are user: Polycom, pass: 456)
  • Enter the Following values:

Identification
Display Name: Your Desired Name

Address: Extension number assigned by FreePBX

Auth User ID: Extension number assigned by FreePBX

Auth Password: Enter your SIP Extension Password assigned by FreePBX

Label: The name you would like this account to have on your phone's display screen

Type: Private

Third Party Name: Extension number assigned by FreePBX

Num Line Keys: 1

Calls Per Line: 3


Server 1/Server 2
Address: Your server ip address assigned by HostPBX.US

Port: Your server port number assigned by HostPBX.US

Transport: UDPonly

Expires: 60

Register: 1

polycom601_02

  • Click on Submit. This will save settings and reboot unit.
  • Codec and DTMF: From the top of the page select General. Then select Audio Processing. Now set the priorities according to the information below:
polycom601_03
  • Clik on Submit. This will save settings and reboot unit.
  • Afer the Device has rebooted, your Device will be ready to be used with HostPBX.US


Help Desk Software by HostPBX.US