Knowledgebase: Device Configuration
Panasonic KX-TGP 550
Posted by HostPBX US on 29 August 2013 02:49 PM


Configuration Details

Complete the following fields:

  • Phone number ID: 100000 (Extension number assigned by FreePBX)
  • Line ID: 100000 (Extension number assigned by FreePBX)
  • Registrar Server Address: (Your server ip address assigned by HostPBX.US)
  • Registrar Server port: 5078 (Your server port number assigned by HostPBX.USt)
  • Proxy server Address: (Your server ip address assigned by HostPBX.US)
  • Proxy server port: 5078
  • Presence server port: 5078
  • SIP service domain: (Your server ip address assigned by HostPBX.US)
  • SIP source port: 5078
  • Authentication ID: 100000 (Extension number assigned by FreePBX)
  • Authentication password: ********* (Enter your SIP Extension Password assigned by FreePBX)

The default registration expiry time on this device is 3600 seconds. You may have to reduce that if you lose registration. Unfortunately, that can not be set on the web interface. You need to load a provisioning configuration file from a web or FTP server. The parm is REG_EXPIRE-n=mmm, where n is line number, and mmm is the registration interval. e.g. REG_EXPIRES_1=300 to set line 1 registration time to 300 seconds. 

The "Phone Number" field may contain only digits, and *must* contain at least one digit, or the base unit won't try to register it. Within those restrictions it can be any number you want. When using the handset (or base unit) to select a line from which to dial, this number will be displayed next to the entry for the associated line. I think Panasonic's idea is that this is supposed to be a DID associated with the SIP address, but it doesn't have to be.

After saving these settings, check the "VoIP Status" page in the "Status" section to see if the status of this line is "registered". This product can register up to eight SIP addresses at once. If any of the SIP addresses you configured into the device do not show their status on this page as being "registered", then the status light on the base unit will flash yellow. (This is not mentioned in either the user guide nor the admin guide for this product.)The above information applies to both the TGP-550 (where the base unit has a handset, dialpad, LCD display, etc.) and the TGP-500 (where the base unit is a faceless black box that sits in your network closet).

Help Desk Software by HostPBX.US